Pro Tips:
Before you get started, make sure to associate the IMEI number with the vehicle number. This makes it easier to activate on the IntelliShift platform.
Getting Started
Installation Tips for Paired Devices:
- These devices are also pre-assigned to specific vehicles by VIN number and cannot be installed in other vehicles.
- The assigned VIN number can be found on the sticker on the outside of the plastic bag, pictured here
- During initial installation, the vehicle should ideally be outside to ensure the best GPS signal. The devices may not report a location to the satellite if it is inside a garage or other structure.
- Watch this video to walkthrough a typical installation and read the step-by-step instructions below. Note that your vehicle and cables may vary slightly from the examples shown here.
OBD and JBUS cables/connectors
For vehicles with an OBDII style port (1996 or newer model years), our OBD connector is required for installation. The harness plugs directly into the vehicles OBDII port and into our device. The device can then be installed under dash as close to the windshield as possible.
For vehicles with a J-Bus style port we offer various types of plugs to suit your installation needs. The harness plugs directly into the vehicles J-Bus port and directly into our device. The device can then be installed under dash as close to the windshield as possible
Installing the 1-Wire Adapter
Installing the VG800 GPS device
For vehicles with a J-Bus style port we offer various types of plugs to suit your installation needs. The harness plugs directly into the vehicles J-Bus port and directly into our device. The device can then be installed under dash as close to the windshield as possible.
Pro Tips:
Before you get started, make sure to associate the IMEI number with the vehicle number. This makes it easier to activate on the IntelliShift platform.
After 15 seconds both lights will come back. Solid Orange means the device has established a connection with our server to report data
Once you see the green light on the gateway blinking, now you can start the engine
Comments
0 comments
Article is closed for comments.