IntelliShift OBD-11 Guide
The following is an install guide on our OBD-11
Install Notes
- The OBD-11 is a pure Plug & Play device. Locate your vehicles OBD Diagnostics port, on most passenger vehicles this is located below the knee panel on the driver side of your interior. Once found, plug the device into the OBD Diagnostics port. Ensure the fit is right and verify that the device now has turned on by looking at the indicator lights on the side. If the device is connected but seems loose, please secure a zip tie around the device and OBD port.
- Status Indicators
- LED #1 (ECM Connectivity - Green) Definitions
-
-
Condition LED 1 OBD/J1939/1708 Protocol not found
Off OBD/J1939/1708 data transmission.
Fast Blinking Deep sleep mode
Slow Blinking (Once Every 10 seconds)
-
- LED #2 (GPS - Blue) Definitions
-
-
Condition LED 2 GPS Off Off GPS No Lock Blinking Every 1 Second GPS Location Locked Solid
-
- LED #3 (Cellular Connectivity - Red) Definitions
-
-
Condition LED 3 Cellular Off Off Network Registered Blinking Every 1 Second Network Connected Blinking Twice Every 2 Second Intellishift Platform Connected Solid
-
If you have any questions during installation, please contact our Service Department at 631-339-7171 for assistance.
Before finalizing installation, please contact our Hardware Verification Department at 631-670-1623 to have them verify the vehicle is visible in Silent Passenger and is registering properly.
Comments
0 comments
Article is closed for comments.