Intellishift AT-502 Follow

Intellishift AT-502 Guide

The following is an install guide on our AT502

Install Notes

• No wiring for these assets, all you’ll need to do is drill Four (4) 5/32” pilot holes and then use the provided 8mm self-tapping bolt to hold the Non-Powered Asset in place.  If using the provided nut and bolt, drill with a 9/32" bit, the bolt is 8mm and the but is 10mm. These devices should be mounted where there is a clear line of sight for GPS and not in the way of any operation for said application.

Before finalizing installation, please contact our Hardware Verification Department at 631-339-7185 to have them verify the vehicle is visible in Silent Passenger and is registering properly.