Intellishift NP-730 Guide
The following is an install guide on our NP-730
Install Notes
- No wiring for these assets, all you’ll need to do is drill Four (4) 5/32” pilot holes and then use the provided 8mm self-tapping bolt to hold the Non-Powered Asset in place. If using the provided nut and bolt, drill with a 9/32" bit, the bolt is 8mm and the but is 10mm. These devices should be mounted where there is a clear line of sight for GPS and not in the way of any operation for said application.
If you have any questions during installation, please contact our Service Department at 631-339-7171 for assistance.
Before finalizing installation, please contact our Hardware Verification Department at 631-670-1623 to have them verify the vehicle is visible in Silent Passenger and is registering properly.
Comments
0 comments
Article is closed for comments.